With the rapid development of modern industry, the demand market for slip rings is gradually expanding. When purchasing slip rings, users often have questions, is the slip ring easy to break? Whether it will break after a period of time can show that users are very concerned about the service life and quality of slip rings. So today, I will analyze the problem that the sliding ring capacity is not easy to break.
First of all, let's understand the slip ring, the slip ring is a precious metal brush in the "II" type and the conductive ring groove symmetrical double contact, with the help of the elastic pressure of the brush and the conductive ring groove sliding contact to transmit signals and current. It is a mechanical wear product, therefore, it has a certain life span. Many users will say that the life of the slip ring is, of course, the longer the better, and it is best to use it for a few years and not be bad for more than ten years. Then the life cycle should be determined according to the user's requirements and the manufacturer's design.
Then it is necessary to ensure that the slip ring will not have instability in signal transmission, short circuit, burnout and other faults during its service life. This involves the quality of the slip ring, the quality of the slip ring is related to many factors, such as the design of the structure of the slip ring, the manufacturing process and the transfer process and the selection of materials are important determinants that directly affect the quality of the slip ring. If the slip ring with low requirements of the ordinary level is properly selected, the design structure is reasonable, and the process and production process are standardized, there will be no problems in the life of the slip ring. Many manufacturers can make it. However, in some high-end application fields, the slip ring has extremely high technical index requirements and is very difficult to achieve, so the manufacturer needs to have a certain research and development ability, otherwise the slip ring made is prone to various problems. At present, due to the limited technical level of domestic slip rings, many high-end application fields need to import slip rings, which have superior performance but are expensive.